133
133
If you plan to attach the printer to your network, you need the optional
EpsonNet print server card. The EpsonNet print server is a 10/100 Base TX
Type B Ethernet interface card (part number C12C82405).
You can purchase the print server card and other optional equipment and
and supplies from EPSON at (800) 873-7766, or you can visit the EPSON
Store at www.epsonstore.com (U.S. sales only). In Canada, please call
(800) 463-7766 for deaer referral.
Make sure you have the correct cable for connecting the printer. To connect
to a network hub, you need a standard RJ-45 “straight-through” network
cable. To connect directly to your computer’s network interface, you need
an RJ-45 crossover cable.
Before you install the print server, make sure you check the documentation
included with the card for additional instructions. Then follow these steps to
install the card:
1. Turn off your computer and printer.
2. IMPORTANT: Unplug the printer from its electrical outlet. Not doing
so may cause damage to the printer and the card.
3. Disconnect any interface cables from the printer.
4. Use a cross-head screwdriver to remove the two screws securing the
optional interface cover. Then lift off the cover as shown:
Make sure you keep the screws in case you need to remove the card and
replace the cover.
Appendix A:
Installing the
Optional Print
Server Card
Caution: You must
unplug the printer from
the power outlet, or you
may damage the printer
and the card.
sp4000Guide.book Page 133 Friday, October 22, 2004 5:06 PM
