Dolphin® 9500 Series User’s Guide Rev A
5/15/07
6 - 13
For On battery power, select the number of minutes of inactivity you want to pass before the terminal powers off
when running on battery power.
For On external power, select the number of minutes of inactivity you want to pass before the terminal powers off
when running on external power.
Options below the tabs
Adjust backlight opens the Backlight settings so that you can make adjustments to conserve power usage; see
Backlight on page 6-8.
Change beam opens beam settings so that you can make adjustments to conserve power usage; see Using
Infrared on page 7-6. (You would turn off receiving capabilities to conserve power.)
You can also set automatic turn-off times for the terminal to conserve power.
When the device is “turned off,” that means that it goes into Suspend Mode (see page 2-6).
Regional Settings
Regional Settings enables you to customize the appearance and formatting to your geographic region. Specifically, you can
customize numbers (number of decimal places allowed, for example), currency (using the $ or
€
€ symbol, for example), time, and
date. These specifications apply to all screens, including the Today screen. To see specific settings or change a specific setting,
tap on one of the tabs, make the change and tap OK to save it.
Remove Programs
The Remove Programs settings enables you to remove programs installed on the terminal. Use this setting to troubleshoot when
you receive messages that the device is out of memory. The programs removed are removed from RAM memory. Any program
(usually *.cab or *.dll files) stored in the Autoinstall folder (My Device > IPSM > Autoinstall) will re-install after the next hard reset.
For information about the Autoinstall process, see Let Autoinstall Run on page 2-4.
For information about the hard reset process, see Hard Reset (Cold Boot) on page 2-6.
1. Tap the Remove Programs icon.
2. In the list, select a program and tap Remove. The following message appears:
3. Tap Yes. Wait while the program is removed.
