FINAL DRIVE 12-25
Front Propeller Shaft
Front Propeller Shaft Removal
•
Slip the O-ring clamps off the grooves on the small rubber
boots [A], and then pull the boot.
•
Push the front propeller shaft [A] rearward, and remove
the front end [B] from the front final gear case.
•
Remove the front propeller shaft from the vehicle.
Front Propeller Shaft Installation
•
Wipe off any old grease on the splines of the propeller
shaft [A] and the coupling [B].
•
Inspect the splines of the propeller shaft and the coupling.
If the splines are twisted or damaged in any way, replace
the parts as needed.
•
Apply molybdenum disulfide grease to all splines.
•
Replace the circlip [C] with a new one, if it is removed.
•
Wipe off any old grease on the splines of the shafts in the
engine and front final gear case.
•
Inspect the O-rings on those shafts for damage.
If any doubt exists, replace the O-rings with new ones.
•
Apply molybdenum disulfide grease to the splines of the
shafts on the output bevel gear and front final gear case.
•
First install the rear end, and then install the front end.
•
Slip the two O -ring clamps into the groove on the small
rubber boot.
O-rings [D]
Boots [E]
Spring [F]
Spring Seat [G]
Front [H]
