Creating an Example Project
12/01 AWB2700-1428GB
28
PROFIBUS-DP expansion
Proceed as follows to expand the configuration with remote I/Os
via PROFIBUS-DP:
Adding a PROFIBUS-DP module to the XC600 controller
X Ensure that the default address CE000 is set on the
modulea Page 13.
X Select Configuration_XC600 in the PLC Configuration window.
Right-click the mouse and choose Append Subelement r
XC-NET-DP-M....
This will open a window with four tabs for setting parameters
(a Figure 51).
X Only change the baud rate in the Bus Parameters tab from
9,600 kBits/s to 1500 or 12000kBit/s.
All other parameters can be left.
Adding a remote XI/ON gateway
X Select the element XC-NET-DP-M and right-click the mouse.
Choose Append Subelement r XN-GW-PBDP-12MB....
The following window with default parameters will appear:
X Select the Input/Output tab to configure the inputs and outputs.
X Select the required input/output modules from the left-hand
column and transfer them to the right column using the Select
button.
The order of the modules in the right-hand column must match the
configuration of the controller.
The bus refreshing module is listed in the Empty Modules group.
Figure 50: Expanding the remote configuration
Figure 51: Changing bus parameters
Figure 52: Adding a XI/ON gateway
Figure 53: Display of PROFIBUS-DP parameters
