Filter
Top Products
3 - Language Dictionary
74
LIST:FREQuency:POINts?
This query returns the number of points specified in LIST:FREQuency. Note that it returns only the total
number of points, not the point values.
Query Syntax
[SOURce:]LIST:FREQuency[:LEVel]:POINTs?
Returned Parameters
<NR1>
Examples
LIST:FREQ:POIN?
Related Commands
LIST:FREQ
LIST:FREQuency:SLEW
This command specifies the output frequency slew list points. The slew points are given in the command
parameters, which are separated by commas. The order in which the points are entered determines the
sequence in which they are output when a list is triggered. Changing list data while a subsystem is in list
mode generates an implied ABORt.
Command Syntax
[SOURce:]LIST:FREQuency:SLEW <NRf+> | INF {,<NRf+> | INF}
Parameters
0 to 9.9E37 | MAXimum | MINimum | INFinity
Unit
HZ
(hertz per second)
Examples
LIST:FREQ:SLEW 10,20,1E2
Query Syntax
[SOURce:]LIST:FREQuency:SLEW?
Returned Parameters
<NR3> {,<NR3>}
Related Commands
LIST:FREQ:SLEW:POIN? LIST:COUN LIST:DWEL
LIST:STEP
LIST:FREQuency:SLEW:POINts?
This query returns the number of points specified in LIST:FREQuency:SLEW. Note that it returns only the
total number of points, not the point values.
Query Syntax
[SOURce:]LIST:FREQuency:SLEW:POINTs?
Returned Parameters
<NR1>
Examples
LIST:FREQ:SLEW:POIN?
Related Commands
LIST:FREQ:SLEW
LIST:PHASe
Phase Selectable
This phase selectable command sets the sequence of phase list points. The phase points are given in the
command parameters, which are separated by commas. The order in which the points are entered
determines the sequence in which they are output when a list is triggered. Changing list data while a
subsystem is in list mode generates an implied ABORt.
Command Syntax
[SOURce:]LIST:PHASe <NRf+> {,<NRf+>}
Parameters
–360 through +360 (degrees) | MAXimum | MINimum
Examples
LIST:PHAS 90,120,150
Query Syntax
[SOURce:]LIST:PHAS?
Returned Parameters
<NR3> {,<NR3>}
Related Commands
LIST:FREQ:POIN? LIST:COUN LIST:DWEL LIST:STEP