Agilent Technologies 6812B Welding System User Manual


 
Language Dictionary - 3
75
LIST:PHASe:POINts?
This query returns the number of points specified in LIST:PHASe. Note that it returns only the total
number of points, not the point values.
Query Syntax
[SOURce:]LIST:PHASe:POINTs?
Returned Parameters
<NR1>
Examples
LIST:PHAS:POIN?
Related Commands
LIST:PHAS
LIST:SHAPe
This command sets the sequence of the waveform shape entries. The order in which the shapes are
given determines the sequence in which the list of shape will be output when a list is triggered. Changing
list data while a subsystem is in list mode generates an implied ABORt. The following shapes may be
specified:
SINusoid
A sinewave is output
SQUare
A squarewave is output
CSINusoid
The output is a clipped sinewave. Both positive and negative peak amplitudes are clipped
at a value determined by the FUNCtion:CSINusoid command.
<table>
The output shape is described by one of the user-defined waveform tables.
The maximum peak voltage that the ac source can output is 425 V peak. This includes any combination of
voltage, voltage offset, and function shape values. Therefore, the maximum value that can be
programmed depends on the peak-to-rms ratio of the selected waveform. For a sinewave, the maximum
voltage that can be programmed is 300 V rms.
NOTE: For Agilent models 6814B, 6834B and 6843A, you cannot program a voltage that
produces a higher volt-second on the output than a 300 Vrms sinewave.
Command Syntax
[SOURce:]LIST[:SHAPe] <shape> {,<shape>}
Parameters
SINusoid | SQUare | CSINusoid | <table>
Examples
LIST:SHAP
Query Syntax
[SOURce:]LIST:SHAPe?
Returned Parameters
<CRD> {,<CRD>}
Related Commands
LIST:SHAP:POIN? LIST:COUN LIST:DWEL LIST:STEP
LIST:VOLT LIST:VOLT:OFFS
LIST:SHAPe:POINts?
This query returns the number of points specified in LIST:SHAP. Note that it returns only the total number
of points, not the point values.
Query Syntax
[SOURce:]LIST:SHAPe:POINTs?
Returned Parameters
<NR1>
Examples
LIST:SHAP:POIN?
Related Commands
LIST:SHAP