Filter
Top Products
BAD BOY™ SPOT LUMINAIRE USER MANUAL
18 02.9812.0001C
Standing Position
The Bad Boy™ Spot Luminaire can also be used in a standing position. Be sure that the floor or stage
will accommodate the load of this moving luminaire.
To install in a standing position:
Step 1. Unlatch and remove case lid (Figure 2-8).
Step 2. Remove Power Cord and Safety Cables from case.
Step 3. Tilt case upright as shown. Use grips on bottom of case to assist in tilting upward.
Step 4. Carefully remove luminaire from case and place in standing position.
Step 5. Connect power and data cables according to "Connecting Power and Data" on page 19.
Figure 2-8: Standing Position
Power Cord and
Case
Safety Cables
Case
1
2
3 4
Grips