Filter
Top Products
INSTALLATION : INSTALLATION PROCEDURES
02.9812.0001C 19
2
Connecting Power and Data
The Bad Boy™ Spot Luminaire may be controlled by DMX512 or Ethernet. The control inputs are
located at the upper enclosure connector panel.
Figure 2-9: Data Connections
Observe the following guidelines when setting up the system:
• The DMX512 Thru port remains active even if the luminaire is not
powered up.
• A maximum of 32
luminaires may be connected in any one DMX512 or Ethernet data link.
However, note that the maximum limit applies to the luminaire "daisy-chain" only. Your system or
console may require fewer luminaires on a single data link path. Consult your console
documentation for more information.
• The Ethernet ports are not assigned as either In or Thru as the DMX512 ports are assigned.
Ethernet can be connected in any configuration.
• Standard "star" topology should be used with Ethernet configurations. DO NOT create a "ring"
with Ethernet.
CAUTION: The Ethernet ports are connected to an internal switch. If power is disconnected to the
luminaire, the switch will go off, therefore cutting communication to downstream luminaires.
Power is provided by the AC Line Cord Cable Assembly (25.9812.0902.5) connected to the Neutrik®
power input connector. There is no power on/off switch.
Note: Refer to "Comm LED Operation" on page 22 for more details about the Comm LED.
CONFIG
addr
043
univ A
1400w
ETHERNET
COMM
IN
DMX
THRU
15A Max
AC IN
200 -240 VAC
50 / 60 Hz
LAMP
hrs
125
temp 34C
INFO
01:34
TEST
COMM
DMX
STATUS
OK
ISPOWERED
ACTIVE ON LY
WHEN FIXTURE
Neutrik® AC
DMX512 Input
DMX512 Thru
Power Connector
Ethernet Input/Output
Ethernet Input/Output