Filter
Top Products
$?2=.?6;43<?&.D#=2?.A6<;@
*<?8=6202&B==<?A
<;4*<?8=6202&B==<?A
<;4D<?8=6202@5.C2 .A2;12;0F
A< A6= <C2? B;92@@ 09.:=21 1<D;
.;1=?<=2?9F@B==<?A213?<:B;12?;2.A5
< ;<A B@2 .;<A52? =2?@<; .@ .
@B/@A6ABA23<? .A./92 2EA2;@6<;<?
.@ .116A6<;.9 @B==<?A Unstable support for the
workpiece can cause the blade to bind or the workpiece
to shift during the cutting operation, causing you to
contact the spinning blade.
#=2?.A6;4 &9616;4 .@2 EA2;@6<;@ – These
extensions provide extra workpiece support and are
especially useful when cutting long workpieces. To
reposition the extensions, simply unlock the base
extension clamping levers, reposition the extensions
and lock the levers (see figure 33). The right extension
lock lever tightens by rotating clockwise and the left lock
lever tightens by rotating counterclockwise.
116A6<;.9*<?8=6202&B==<?A
9<08@ – Long pieces need extra support. The base
height is 3-7/16 inches. Cut two 2x4 pieces to 3-7/16" in
length and fasten together. Boards of this thickness and
height can be used to create auxiliary support
extensions for long workpieces, figure 34.
Always ensure that supporting
surfaces are able to properly support
the workpiece and allow for secure holding by hand
outside of the “No Hand Zone”, or clamping with a clamp
inside or outside of the “No Hand Zone” – see page 24
for “No Hand Zone” and appropriate hand positions.
9D.F@ .17B@A A52 @9616;4 /.@2
2EA2;@6<; A< @B==<?A D<?8=6202
Unsupported workpiece can move out of position during
cut and cause injury and/or tool damage.
2 .D.?2 <3 A52 =.A5 <3 A52 @.D
/9.12!.82.1?F?B;D6A5A52@.D
#33 /F 0<;1B0A6;4 . @6:B9.A21 0BAA6;4 0F092 .;1
</@2?C2A52=?<720A21=.A5<3A52@.D/9.1222=
5.;1@.A92.@A@6E6;052@.D.F3?<:A52=?<720A21
=.A5<3A52@.D/9.12
3-7/16"
Two
2x4 Pieces
.@2EA2;@6<;
9.:=6;4 2C2?
FIG. 33
FIG. 34
*%""
!
*%""
!
*%""
!
*%""
!
*%""
!
BM 2610025580 05-13_BM CM8S 5/17/13 1:37 PM Page 27