Filter
Top Products
$%# !
Tool vibrates or shakes.
Head assembly does not slide
freely when attempting a slide cut.
Blade does not cut completely
through workpiece.
Saw blade or lower guard cuts or
contacts sliding fence when saw is
set for bevel cuts.
(&
1. Saw blade not round.
2. Saw blade damaged.
3. Saw blade loose.
4. Other
Slide rail lock knob is engaged.
1. Depth stop plate is pulled out for
non-through cuts.
2. Replacement blade is less than
8
1
⁄2" diameter.
Sliding fence is not moved out from
path of saw blade before making
bevel cut.
#%%')'#"
- Replace blade.
- Replace blade.
- Check that blade is properly
seated on the inner washer. See
Removing and Installing Blades
on page 13.
- Authorized service.
Rotate slide rail lock knob counter
clockwise to disengage.
- Push depth stop plate inward to
set for full-depth cuts
(see page 16).
- Change to a blade that is fully
8
1
⁄2" diameter.
Move sliding fence to be clear of
lower guard and saw blade;
perform a “dry cut” to check for
clearances before making bevel
cuts (see page 26).
'?<B/92@5<<A6;4
'?<B/92@5<<A6;4B6122;2?.9
002@@<?62@
!6A2?6;12?Q 646A.9 ;492
36;12?<:=<B;1BA.90B9.A<?$?<A?.0A<? 2C29
– Gives you the information needed to position cuts
so that they fit together precisely even if the room is
out of square.
!& ?<D; &A<= &2A – Correctly hold crown
molding in an inclined position against fence. Set
molding for simple vertical cutting – no compound
cutting required.
'$<?A./92&A.;1D6A5*5229@
'?.C6AF%6@2*522921!6A2?&.D&A.;1
!& 2;4A5&A<=
BM 2610025580 05-13_BM CM8S 5/17/13 1:37 PM Page 44