Filter
Top Products
The preferred method for cutting crown molding with this
saw is with the molding lying flat on the table. The
advantage to cutting molding angled against fence is
that no bevel setting is required, only the miter angle is
adjusted.
The maximum crown molding width that can be cut and
angled to table and fence is 3-1/2" at a 38 spring angle.
When cutting crown molding in this fashion it is
recommended to purchase and use the optional Crown
Stop Set (see page 44).
<99<DA52@26;@A?B0A6<;@3<?0BAA6;4
0?<D;:<916;4.;4921A<A./92.;132;02
1. Position the molding so the bottom (decorative part,
which is installed against the wall) is against the
fence, figure 46.
2. For 90° corner, set the miter angle using chart below.
Tighten the miter lock knob.
3. Support crown molding against the fence (see “Body
and Hand Position” on page 24.)
2 .D.?2 <3 A52 =.A5 <3 A52 @.D
/9.12!.82.1?F?B;D6A5A52@.D
#33 /F 0<;1B0A6;4 . @6:B9.A21 0BAA6;4 0F092 .;1
</@2?C2A52=?<720A21=.A5<3A52@.D/9.1222=
5.;1@.A92.@A@6E6;052@.D.F3?<:A52=?<720A21
=.A5<3A52@.D/9.12
4. Follow the procedures for chop or slide cut (see page
29).
5. Wait until blade comes to a complete stop before
returning head assembly to the raised position
and/or removing workpiece.
NOTE: Always take a test cut using scrap to confirm
correct angles.
&.D#=2?.A6<;@
?<D;!<916;4;4921A<'./92.;12;02
45° Miter
Optional
Crown Stop
Crown Molding
Angled Against
Fence
Bottom
Edge of
Molding
FIG. 46
*%""
!
BM 2610025580 05-13_BM CM8S 5/17/13 1:37 PM Page 35