Filter
Top Products
'< .C<61 6;7B?F 3?<: .00612;A.9
@A.?A6;4?2:<C2=9B43?<:=<D2?
@<B?02<BA92A/23<?2:.86;4.;F.17B@A:2;A@
&D6A05 <08# %292.@2 BAA<;@ – One of
these two buttons must be pressed before the
power switch can be pressed.
$<D2?&D6A05 – The power switch used with the
switch “Lock-OFF” release button energizes the
unit.
!.6;.;192 – This handle contains the power
switch. Pulling this handle down lowers the blade
into the workpiece.
<D2? 9.12 B.?1 – The lower blade guard
helps protect your hands from the spinning
blade. It retracts as the blade is lowered.
9.12 – Use only 8
1
⁄2" (216 mm) diameter blades
with
5
⁄8" (15.88 mm) diameter arbor holes.
56= 23920A<? – Deflects cut-off workpieces
from entering the upper guard.
(==2? B.?1 – Covers upper portion of the
blade.
&9616;4 2;02 – Supports the workpiece. The
fence also has holes to secure an auxiliary fence
if desired.
&A.A6<;.?F2;02 – Stationary fence is bolted
to the base and will support the workpiece when
the sliding fence is removed.
2?3 ;@2?A@ – Kerf inserts can be adjusted to
different blade widths to minimize workpiece
tear-out.
!6A2?2A2;A#C2??612 – Allows detent action to
be locked out, allowing for micro-adjustments to
any miter angle.
!6A2? <08;</ – The miter lock knob locks the
miter saw table at any desired miter angle.
!6A2? 2A2;A 2C2? – The lever releases the
table from the detent.
?<;A &A./696G6;4 <<A – Provides additional
support and stability when making slide cuts.
!6A2?&0.92!6A2?$<6;A2? – The pointer rotates
with the table and blade. It points to the miter
scale to indicate the angle setting before a cut is
made.
!6A2? 2A2;A $9.A2 – The position of the plate
can be adjusted to set the accuracy of its detent
locations.
!6A2?2A2;A@ – There are ten (10) miter detent
slots for fast and accurate miter cuts of common
miter angles.
'./92 – Sits in base, provides workpiece support,
rotates for desired miter cuts and rotates the
head assembly. The front extended part of the
table is called the miter arm.
'<<9!<B;A6;4$.1@ – The four corners of the
saw provide areas to clamp, bolt or nail the saw
to a flat work surface.
*%""
!
2AA6;4'<;<D,<B?!6A2?&.D
BM 2610025580 05-13_BM CM8S 5/17/13 1:37 PM Page 8