Filter
Top Products
SKU 91482 For technical questions, please call 1-800-444-3353. Page 11
ALUMINUM
BASE
(38)
ALUMINUM
COLUMN
(35)
BOLT (30)
LARGE WASHER (32)
BOLT (59)
WASHER (58)
POSITION TUBE
(57)
SHAFT
(36)
REAR VIEW
FIGURE D
KNOB
(31)
ASSEMBLY INSTRUCTIONS
NOTE: For additional information regarding the parts listed in the following pages, refer to the
Assembly Diagram on page 19.
1. WARNING! Always make sure the Power Switch of the Tile Saw is in its “OFF”
position and the unit is unplugged from its electrical outlet
prior
to assembling the unit,
adding any accessories, or making any adjustments to the unit.
2. Mount the Tile Saw to the machine frame by connecting the Aluminum Base (38) to the
Aluminum Column (35), using the Shaft (36), Position Tube (57), Bolt (30), Large Washer
(32), Bolt (59), and Washer (58). (See Figure D.)
3. Tighten the Knob (31) to hold the Tile Saw in position. (See Figure D.)
4. At this time remove the Bolts (76) that hold the Pulley Cover (75) on, remove the Cover,
and check that the Belt (74) is tight and in good condition. It should deflect (move) a
little (about 1/2” deflection) when pressed with the thumb.
If the Belt is loose, do the following:
a. Loosen all 4 Nuts (46) that hold down the Motor (45).
b. Gradually tighten the Belt Tension Bolt (41), all the while checking the tension on
the Belt - see Figure D. Tighten the Belt to about 1/2” deflection. Do not over-
tighten; overtightening can cause damage to the bearings in the Motor.
c. Retighten all 4 Nuts (46).
d. Reinstall the Pulley Cover (75) using the Bolts (76).
5. Slide the Water Tank (3) through the slot in the Machine Frame (11) and under the
Aluminum Bar (83), so that the entire Water Tank rests inside the Machine Frame.
(See Figure E, next page.)
BELT TENSION
BOLT (41)