Filter
Top Products
SKU 91482 For technical questions, please call 1-800-444-3353. Page 15
OPERATING INSTRUCTIONS
1. Place the Saw (or saw and stand, if the optional stand is installed) on a level, even
surface, capable of supporting the tool and any forces exerted during work. Fill the
Water Tank (3) with enough cold water so that the Pump (105) is completely sub-
merged, but not so much water that the Water Tank overflows.
NOTE: To prevent excessive wear on the Saw Blade (65), make sure to maintain a
continuous flow of water over the entire Saw Blade while cutting. Never cut anything
if the water flow is not continuous.
2. To attach the Parallel Guide (84), loosen the Knob (86) on the side of the Guide.
Place the hooked portion of the Guide over the upturned edge of the Main Table (99).
Slide the Guide horizontally to the right or left until the desired width of cut is ob-
tained (allowing space for grout). Then, tighten the Knob to lock the Guide in posi-
tion. (See Figure M.)
FIGURE M
KNOB
(86)
PARALLEL
GUIDE
(84)
MAIN
TABLE
(99)
3. Attach the Angle Block (85) as you did the Parallel Guide, using the two Knobs (86)
on the side of the Guide. Use the cutting groove in the middle of the Main Table to
brace the edge of the tile as the tile is slid underneath the Saw Blade (65).
(See Figure N.)
ANGLE BLOCK
(85)
KNOB
(86)
FIGURE N