Filter
Top Products
SKU 91482 For technical questions, please call 1-800-444-3353. Page 13
CHANGING OR INSTALLING A SAW BLADE
1. WARNING! Always make sure the Power Switch of the Tile Saw is in its “OFF”
position and the unit is unplugged from its electrical outlet
prior
to assembling the
unit, adding any accessories, or making any adjustments to the unit.
2. Loosen the Knob (53) located on the side of the Blade Guard (60) and raise the
Blade Guard. (See Figure H.) Then, retighten the Knob to lock the Blade Guard in
the “up” position.
FIGURE H
BLADE GUARD
(60)
KNOB
(53)
(DOWN POSITION)
3. Depress the Brake Shaft (68) while turning the Saw Blade (65) (or Spindle (80) if you
have not yet installed a Saw Blade) until the Brake Shaft (68) depresses fully. This
will prevent the Spindle from spinning.
(See Figure I, next page.)
4. Using the accessory Wrench, unscrew the Nut (67) counterclockwise and remove it
and the Outer Flange (66). (See Figure J, next page.)
5. Using heavy duty gloves to avoid accidental cuts, remove the old Saw Blade (65) and
install a new Saw Blade. Always use Continuous Rim, Diamond Saw Blades
with a 10” diameter, 5/8” round arbor hole, and rated at 3,500 RPM or greater.
(See Figure K, next page.)
6. NOTE: When installing a Saw Blade (65), make sure the “ARROW” depicted on
the upper side of the Saw Blade points to the front of the Tile Saw.
(See Figure K.)