Filter
Top Products
SKU 91482 For technical questions, please call 1-800-444-3353. Page 17
INSPECTION, MAINTENANCE, AND CLEANING
1. WARNING! Make sure the Power Switch of the Tile Saw is in its “OFF” position
and that the unit is unplugged from its electrical outlet before performing any inspec-
tion, maintenance, or cleaning procedures.
2. Before each use, inspect the general condition of the Tile Saw. Check for loose screws,
misalignment or binding of moving parts, damaged electrical wiring, damaged Hose,
and any other condition that may affect its safe operation. If abnormal noise or vibra-
tion occurs, have the problem corrected before further use. Do not use damaged
equipment.
3. Before each use, inspect the Diamond Saw Blade. Using a dull Saw Blade will cause
excessive wear on the Motor, and will not produce a satisfactory cut. Replace with a
new Saw Blade when needed.
4. Before each use, inspect the mounting Screws on all Safety Covers and the Arbor Nut
on the Saw Blade Shaft. If necessary, retighten all loose Screws and Nuts.
5. NOTE: The Pump is non-serviceable. If the Pump should fail, first try clearing the
intake of debris and make sure the hole is not plugged. If the Pump still does not
operate properly, it must be replaced.
6. To clean the exterior parts: Use only a clean cloth and mild detergent to clean the
body of the Tile Saw. Do not use solvents.
Do not immerse any electrical part of the
tool in liquid.
7. When storing, always completely empty the Tile Saw of water. Frost will damage the
Pump if the unit contains water. Store the Tile Saw indoors in a dry, frost-free room.
8. Periodically, remove the Pulley Cover (75) as explained under
Assembly Instruc-
tion 4
on page 11 and check the condition and tightness of the Belt (74). If the belt
appears damaged (frayed, cracked, or partially broken) or is broken, loosening the 4
Nuts (46) and the Belt Tension Bolt (41), replace the Belt (74) and retighten it as ex-
plained on page 11.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEM-
BLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE
OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED
TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR
EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY
CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK
AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACE-
MENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS
THERETO.