Filter
Top Products
SKU 91482 For technical questions, please call 1-800-444-3353. Page 16
4. Attach the 45° Miter Block (108) as you did the Parallel Guide, using the Knob (86)
on the side of the Guide. (See Figure O.)
FIGURE O
45° MITER
BLOCK
(108)
KNOB
(86)
5. Plug the Power Cord of the Tile Saw into the nearest, 120 volt, grounded, electrical
outlet.
6. Make sure to wear an ANSI approved safety impact full face shield over ANSI
approved safety glasses and a dust mask when cutting tile. At all times, keep
hands and fingers away from the spinning Saw Blade (65).
7. Place the marked tile on the Main Table (99) and brace it against the Guide you have
chosen to use. Then, align the cut mark with the Saw Blade (65).
8. Turn the Flow Control Lever (105D) all the way down. Turn the Power Switch to its
“ON” position, and allow the Saw Blade (65) to spin up to full speed. Adjust the Flow
Control on the Pump until the water reaches the edge of the Blade just before the
Blade would contact the material being cut. Make sure the Pump (105) is supplying
a continuous flow of water to the entire Saw Blade. (See Figure O.)
9. Make sure the Blade Guard (60) is in place and in proper working order. Hold the tile
firmly against the Guide with one hand. With the other hand, move the Main Table
(99) and tile
slowly
underneath the Saw Blade (65).
10. Continue moving the Main Table (99) and tile underneath the Saw Blade (65) until
the cut is completed.
11. Once the cut is completed turn the Power Switch to its “OFF” position, and allow the
Saw Blade (65) to stop on its own. Then remove the cut tile and debris from the
Main Table (99), and unplug the Power Cord from the electrical outlet.
12. NOTE: If the Motor (45) stops suddenly while cutting, turn the Power Switch to
its “OFF” position. Wait approximately 5 minutes. Then reset the Circuit Breaker
to resume cutting. (See Figure O.)
POWER SWITCH
CIRCUIT BREAKER