Filter
Top Products
SKU 91482 For technical questions, please call 1-800-444-3353. Page 9
13. Do not use the Tile Saw for cutting metals or for cutting curves. This may
cause the Saw Blade to break and/or reduce its service life.
14. Make sure the Saw Blade is wet at all times when cutting.
15. Keep all electrical connections dry and off the ground.
16. Use cold water only. Never use hot water. Using hot water can damage the
Pump seals.
17. Never run the Tile Saw without a water supply. Running the unit without a
water supply will cause irreparable damage to the Pump, Motor, or Blade.
18. Make sure the water supply used for the Tile Saw is not dirty, sandy, and
does not contain any corrosive chemical products. Always add fresh, clean
water before using the unit.
19. Never leave the Tile Saw unattended when it is plugged into an electrical
outlet. Turn off the Tile Saw, and unplug it from its electrical outlet after use.
20. Always keep the water level at the recommended level. Fill the Tank with
enough water so that the Pump’s inlet is completely submerged, but not so much
water that the Tank overflows.
21. Never splash water on the Motor, Power Switch, Power Cord, or any other
electrical component. Make sure to stand on a dry, insulated surface such as a
rubber mat while using the Tile Saw.
22. Make sure to clean the Tank thoroughly after each use.
23. To avoid accidental injury, always wear heavy duty work gloves when
changing the Saw Blade.
24. Before using the Tile Saw, make sure the Saw Blade is properly mounted
on the Saw Spindle. Make sure the Saw Blade is balanced, and is not cracked
or bent.
25. The Saw Blade may become hot while cutting. Allow the Saw Blade to com-
pletely cool before handling.
26. Allow the Saw Blade to spin up to full speed before feeding a workpiece
into it. When turning off the Tile Saw, allow the Saw Blade to spin down and
stop on its own. Do not press against the Saw Blade to stop it.
27. Do not force the workpiece into the Saw Blade when cutting. Apply moder-
ate pressure, allowing the Saw Blade to cut without being forced.