Filter
Top Products
5-20
Cisco MGX Route Processor Module (RPM-PR) Installation and Configuration Guide
Release 2.1, Part Number 78-12510-02 Rev. C1, August 31, 2004
Chapter 5 Configuring the MGX RPM-PR
Establishing 1:N Redundancy Between Two or More RPM-PR Cards
Step 6 Continue this procedure from Step 2 for all remaining cards.
Upgrading Non-redundant RPM-PR Cards
The following procedure describes how to upgrade non-redundant RPM-PR cards.
Step 1 Configure the RPM-PR card to store its configuration on the PXM hard disk by entering the boot config
e:auto_config_<slot#> command or by saving it in NVRAM by entering the WR MEM command.
Step 2 Modify the running configuration to boot from the new upgrade software by entering the boot system
command.
Step 3 Enter WR MEM to save the configuration.
Step 4 Reset the RPM-PR card by entering the reset command from the PXM or the reload command from the
RPM-PR.