Filter
Top Products
CHAPTER
3-1
Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide
OL-26701-02
3
Installing Modules and Cables in the Chassis
This chapter contains the procedures for installing cards and modules into the chassis, after it has been
installed in a rack. It also describes how to connect cables to the ports and RP.
The installation is presented in these sections:
• Fixed 4x10-Gigabit Ethernet Ports, page 3-1
• Modular Port Adapters, page 3-2
• Installing and Removing Modular Port Adapters, page 3-5
• Installing and Removing SFP Modules, page 3-11
• Installing and Removing XFP Modules, page 3-11
• Cable Management, page 3-12
• Connecting Route Processor Cables, page 3-16
• Connecting Power to the Router, page 3-18
• Powering on the Router, page 3-21
Fixed 4x10-Gigabit Ethernet Ports
The Cisco ASR 9001 Router has four integrated 10 GE small form-factor pluggable (SFP+) ports that
operate at a rate of 10 Gbps.
Each fixed SFP+ port has an adjacent Link LED visible on the front panel. The Link LED indicates the
status of the associated SFP+ port.
Note In Cisco ASR 9001-S Router, two 10 GE fixed SFP+ ports (SFP+2 and SFP+3) are disabled by default,
and can be enabled by a license upgrade.
Figure 3-1 shows the front panel of the chassis and connectors of the fixed 4x10-Gigabit Ethernet ports.