Filter
Top Products
4-8
Cisco Aironet 1100 Series Access Point Hardware Installation Guide
OL-4309-07
Chapter 4 2.4-GHz Radio Upgrade for Autonomous Access Points
Replacing the Back Cover
Replacing the Back Cover
To replace the back cover on the access point, follow these steps:
Step 1 While holding the back cover near the connector end of the access point, position it at a slight angle and
carefully place the latches on the antenna end into the detents on the antenna end of the front cover (refer
to Figure 4-6).
Figure 4-6 Positioning the Back Cover Latches
Step 2
Release the back cover and with one finger gently push the connector end of the back cover towards the
antenna end. The back cover drops into place and slides forward until it is fully seated.
Step 3 Use a Philips screwdriver to hand tighten the cover’s retaining screw.
Step 4 Remove the backing paper from the 1100 series access point product compliance label and carefully
place the new label over the existing label (see Figure 4-7).
Figure 4-7 Location of Compliance Labels
1 Back cover 3 Antenna end detent
2 Antenna end latch 4 Front cover
97572
3
4
2
1
1 Product compliance label 2 Back cover
95756
1
2