Filter
Top Products
12
PA-4R Half-Duplex Token Ring Port Adapter Installation and Configuration
OL-3589-01
What Is the 4R Port Adapter?
4R Port Adapter Receptacles, Cables, and Pinouts
A network interface cable provides the connection between the 9-pin Token Ring receptacles on the 4R
port adapter and a media access unit (MAU). The 9-pin connector at the 4R port adapter end and the
MAU connector at the network end are described in the section “Token Ring Connection Equipment” on
page 8.
4R Port Adapter Cables
The Token Ring ports on the 4R port adapter are DB-9 (PC type) receptacles that require Type 1 or Type
3 lobe cables. Token Ring interface cables are not available from Cisco Systems, but are commercially
available through outside cable vendors.
Type 1 lobe cables use shielded twisted-pair (STP) cable and terminate at the network end with a large
MAU plug. (See Figure 6.) The 4R port adapter end of the cable is a DB-9 plug.
Figure 6 Token Ring Type 1 Lobe Cable Connectors (DB-9 and MAU Types)
Type 3 lobe cables use either shielded or unshielded twisted-pair (UTP) cable and terminate at the
network end with an RJ-11 plug. (See .) The 4R port adapter end of the cable is a DB-9 plug.
Figure 7 Token Ring Type 3 Lobe Cable Connectors (DB-9 and RJ-11 Types)
H5761
4R port adapter end
MSAU or
MAU end
H5762
4R port adapter end
MAU end