Filter
Top Products
16
PA-4R Half-Duplex Token Ring Port Adapter Installation and Configuration
OL-3589-01
VIP2 and the 4R Port Adapter
Figure 10 Pulling a Port Adapter Out of a Slot (Partial Port Adapter View)
Step 7
If you removed a port adapter, place it in an antistatic container for safe storage or shipment back to the
factory. If you removed a blank port adapter, no special handling is required; however, store the blank
port adapter for potential future use.
Step 8 Remove the new port adapter from its antistatic container and position it at the opening of the slot. (See
Figure 11.)
Step 9 Carefully align the port adapter carrier between the upper and lower edges of the port adapter slot, as
shown in Figure 11.
Figure 11 Aligning a Port Adapter in a Port Adapter Slot
Caution To prevent jamming the carrier between the upper and lower edges of the port adapter slot and to ensure
that the edge connector at the rear of the port adapter seats in the connector at the rear of the port adapter
slot, make certain that the leading edges of the carrier are between the upper and lower slot edges, as
shown in the cutaway in Figure 11.
H3149
H3150
Upper edge
Lower edge
Carrier