Filter
Top Products
21
PA-4R Half-Duplex Token Ring Port Adapter Installation and Configuration
OL-3589-01
VIP2 and the 4R Port Adapter
Router> enable
The EXEC prompts you for a privileged level password:
Password:
Step 2 Enter the password.
For security purposes, the password is not displayed. (Also note that the password is case sensitive).
When you enter the correct password, the system displays the privileged mode system prompt:
Router#
To configure Token Ring interfaces using the setup EXEC command facility, follow the instructions in
the section “Using the Setup Command Facility.” To configure the Token Ring interfaces by using the
configure EXEC command, follow the instructions in the section “Determining Chassis Slot, Port
Adapter, and Token Ring Interface Port Numbers” on page 19.
Using the Setup Command Facility
The setup command facility identifies all interfaces (including the Token Ring interfaces for the ports
on the 4R port adapter) that are installed and prompts you for configuration information for each
installed interface. When you finish configuring one interface, the setup command facility prompts you
for the next, continuing until each interface has been configured.
When you enter the setup command facility after first time startup, you must run through the entire
dialog until you come to the interface you want to change. Note that when you use the setup command
after first time startup, the default values indicated within the brackets in the System Configuration
Dialog are the values last set using the setup command facility or left as defaults.
After you choose to continue with the setup command (by answering yes to the system configuration
dialog prompt), the remainder of the script is the actual configuration process. The dialog prompts you
first for global system parameters, then for configuration information for each interface. The existing
configuration is displayed as the default, in brackets ([ ]), at the end of each prompt. Press Return to
accept the default settings.
Note After you start the setup command facility, the system runs through the entire configuration process; you
cannot quit out of it. To make a change or correct a mistake, press the Return key at each prompt, answer
no when asked if you want to save the configuration, and restart the setup facility.
Use the setup command facility to configure the 4R Token Ring interfaces, as follows:
Step 1 After you access the privileged level of the EXEC, as described in the section “Using the EXEC
Command Interpreter” on page 20, enter the setup command to begin the setup facility:
Router# setup
Step 2 The following script is displayed on the screen, with the name of your router as the default in the
brackets.
-System Configuration Dialog-
At any point you may enter a question mark ‘?’ for help.
Refer to the ‘Getting Started’ Guide for additional help.
Default settings are in square brackets ‘[]’.
Continue with configuration dialog? [yes]: