Filter
Top Products
Chapter 2 Installing the SN 5428 Storage Router
Read Safety Notices
2-4
Cisco SN 5428 Storage Router Hardware Installation Guide
OL-4796-01
Warning
The safety cover is an integral part of the product. Do not operate the unit
without the safety cover installed. Operating the unit without the cover in place
will invalidate the safety approvals and pose a risk of fire and electrical
hazards. To see translated versions of the warning, refer to the Regulatory
Compliance and Safety document that accompanied the device.
Warning
Blank faceplates and cover panels serve three important functions: they
prevent exposure to hazardous voltages and currents inside the chassis; they
contain electromagnetic interference (EMI) that might disrupt other equipment;
and they direct the flow of cooling air through the chassis. Do not operate the
system unless all cards, faceplates, front covers, and rear covers are in place.
To see translated versions of the warning, refer to the Regulatory Compliance
and Safety document that accompanied the device.
Warning
Before working on equipment that is connected to power lines, remove jewelry
(including rings, necklaces, and watches). Metal objects will heat up when
connected to power and ground and can cause serious burns or weld the metal
object to the terminals. To see translated versions of the warning, refer to the
Regulatory Compliance and Safety document that accompanied the device.
Warning
A voltage mismatch can cause equipment damage and may pose a fire hazard.
If the voltage indicated on the label is different from the power outlet voltage,
do not connect the chassis to that receptacle. To see translated versions of the
warning, refer to the Regulatory Compliance and Safety document that
accompanied the device.
Warning
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits
to telephone-network voltage (TNV) circuits. LAN ports contain SELV circuits,
and WAN ports contain TNV circuits. Some LAN and WAN ports both use RJ-45
connectors. Use caution when connecting cables. To see translated versions of
the warning, refer to the Regulatory Compliance and Safety document that
accompanied the device.