Filter
Top Products
Chapter 2 Installing the SN 5428 Storage Router
Installing the SN 5428 Chassis
2-6
Cisco SN 5428 Storage Router Hardware Installation Guide
OL-4796-01
Installing the SN 5428 Chassis
You can install the SN 5428 chassis on a table or a shelf, or in an equipment rack.
The following sections describe the steps required to install the SN 5428 chassis:
• Installing on a Table or a Shelf, page 2-6
• Rack-Mounting the SN 5428 Storage Router, page 2-7
• Attaching the Optional Cable Guide, page 2-10
Before installing the storage router, read the Site Preparation and Safety Guide to
familiarize yourself with proper site and environmental conditions.
Installing on a Table or a Shelf
You can install the SN 5428 Storage Router chassis on a table or a shelf (or
another flat, secure surface).
If you are going to install the SN 5428 Storage Router in an equipment rack, skip
this section and proceed to the “Rack-Mounting the SN 5428 Storage Router”
section on page 2-7. To install the chassis on a table or a shelf, follow these steps:
Step 1 Locate the four adhesive-backed rubber feet. They are in the accessory kit that is
shipped with the storage router.
Step 2 Peel the rubber feet from their backing and place the feet, adhesive-side down,
onto the four round recessed areas on the bottom of the chassis.
Step 3 Place the storage router on a table or a shelf near an AC power source.