Filter
Top Products
UNPACKING ,_
This product requires assembly.
[] Carefully lift saw from the carton and place it on a level
work surface.
NOTE: This tool is heavy. To avoid back injury, keep
your knees bent and lift with your legs, not your back,
and get help when needed.
_, WARNING: Do not use this product if any parts on
the Loose Parts List are already assembled to your
product when you unpack it. Parts on this list are not
assembled to the product by the manufacturer and A
require customer installation. Use of a product that
may have been improperly assembled could result in
serious personal injury.
[] Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
[] Do not discard the packing material until you have
carefully inspected the tool, identified all loose parts,
and satisfactorily operated the tool.
NOTE: Remove the foam block from between the saw's
housing and the motor by first beveling the blade (see
page 26).
[] The saw is factory set for accurate cutting. After
assembling it, check for accuracy. If shipping has
influenced the settings, refer to specific procedures
explained in this manual.
[] If any parts are damaged or missing, please call
1-800-932-3188 for assistance.
A
WARNING: If any parts are damaged or missing, do
not operate this tool until the parts are replaced. Use
of this product with damaged or missing parts could
result in serious personal injury.
A
WARNING: Do not attempt to modify this tool
or create accessories not recommended for use
with this tool. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
A
WARNING: Do not connect to power supply until
assembly is complete. Failure to comply could result
in accidental starting and possible serious personal
injury.
WARNING: Do not lift the saw without help. Hold
it close to your body. Keep your knees bent and lift
with your legs, not your back. Ignoring these precau-
tions can result in back injury.
WARNING: Never stand directly in line with the
blade or allow hands to come closer than 3 in. to the
blade. Do not reach over or across the blade. Failure
to heed this warning can result in serious personal
injury.
WARNING: To avoid serious personal injury, always
make sure the table saw is securely mounted to a
workbench or an approved leg stand. NEVER oper-
ate the saw on the floor.
MOUNTING HOLES
The table saw must be mounted to a firm supporting
surface such as a workbench or leg stand. If bolted to
a workbench, remove the four locking knobs. Four bolt
holes have been provided in the saw's base for this pur-
pose. Each of the four mounting holes should be bolted
securely using 3/8 in. machine bolts, lock washers, and
hex nuts (not included). Bolts should be of sufficient
length to accommodate the saw base, lock washers, hex
nuts, and the thickness of the workbench. Tighten all four
bolts securely.
Carefully check the workbench after mounting to make
sure that no movement can occur during use. If any tip-
ping, sliding, or walking is noted, secure the workbench to
the floor before operating.
TO ASSEMBLE THE LEG STAND
See Figures 6- 7.
NOTE: Do not use this leg stand with other equipment or
for other purposes.
[] Place the leg stand on the floor.
[] Keeping fingers and all body parts away from the
stand's moving parts, open the leg stand by pushing
opposite legs in opposite directions as indicated by the
arrows in figure 6. The stand will be fully opened when
the red indicator rests in the V slot of the grip.
NOTE: Only mount the saw when the stand is
completely opened.
15