Filter
Top Products
TO ASSEMBLE THE SLIDING TABLE
ASSEMLBY
See Figures 17- 18.
To install s(iding table extension:
[] Locate the sliding table assembly.
[] Unlock the front and back table locking levers.
[] Insert sliding table assembly into table locking levers.
[] Push the table assembly until it rests against the saw
table and is completely closed.
[] Install phillips head screw into hole at end of the rear
extension rod to hold sliding table assembly into lock-
ing levers.
[] Lock the front and back table locking levers.
To install indicator:
[] Locate the indicator.
[] Slip the indicator in the slot on the front rail. Fit the top
slot in the indicator over the detent on the end plug
and the bottom slot over the screw hole on the end
plug.
[] Insert a screw into the bottom slot of the indicator, the
hole in the end plug and the extension rod. Tighten se-
curely, but do not overtighten. Overtighting may crush
extension rod ends.
SCREW
%
(
REAR
EXTENSIONROD
DETENT
_ SCREWHOLE
/
ENDPLUG
SLIDING
TABLE
ASSEMBLY
Fig. 17
INDICATOR
EXTENSION
ROD
TABLE
LOCKING
LEVER
SCREW Fig. 18
20