Filter
Top Products
I CRAFTSMAN°I
LOCKING SYSTEM
Parts Replacement
Actuator Channel
Actuator Rod Bracket
ACTUATOR ROD AND ACTUATOR CHANNEL REPLACEMENT
ACTUATOR ROD AND ACTUATOR
CHANNEL REMOVAL
• Disconnect power from the unit.
• Remove work surface (Roll-away
only).
• Remove pull out work surface (Roll-
away only.) See drawer and work
surface installation and removal.)
• Remove enough drawers to reach the
top back inside of the unit, (See
drawer and work surface installation
and removal.)
• Push actuator rod to back of unit to
disconnect from back of lock.
• Rotate actuator rod straight down.
• Pull out to remove.
ACTUATOR CHANNEL REMOVAL
• Move actuator channel fully to the
right to remove from mounting
flanges.
ACTUATOR CHANNEL
INSTALLATION.
• Install slot in actuator channel over pin
on lock bar. Move actuator channel
fully to the right.
• Insert top flanges on actuator channel
into mounting flanges on inside top of
unit.
ACTUATOR ROD INSTALLATION
• Insert actuator rod into hole in
actuator channel as shown.
• Insert back of actuator rod into
actuator rod holder in top back of unit.
• Push actuator rod toward back of unit
and line up with lock. Insert actuator
rod into back of lock.
• Test lock operation.
• Reinstall drawers.
• Reconnect power to the unit.
Remove lock bar
through top of unit
Move actuator
channel fully to
right to remove
Actuator rod to
actuator channel
Flexible tab
front
Actuator rod
Lockbar
Sears, Roebuck and Co., Hoffman Estates, IL 60179, USA
F1618 2