Craftsman 706.59668 Tool Storage User Manual


 
DRAWER AND WORK SURFACE REPLACEMENT DRAWER FRONT INSTALLATION AND REMOVAL
Tools Required:
Drill
5/32" Drill bit
Rivet gun
Crosstip screwdriver
Removal
Remove drawer or work surface from
unit. (See Drawer and Work surface
installation and removal.)
Carefully drill out rivets holding slides
to drawer.
Rotate front of slide down and out.
Pull slide forward to remove.
Drawers only
Remove striker. (See striker
replacement.)
Remove drawer front. (See drawer
front replacement.)
Installation
Install slides on new drawer or work
surface. (install back hangers first.)
Install rivets to hold slides in place.
Drawers only
Install striker. (See striker
replacement.)
Install drawer front. (See drawer front
replacement.)
Drawers and work surface
Install drawer or work surface in unit.
See drawer and work surface
installation and removal.
Tools Required:
Crosstip screwdriver
Removal
Remove retaining screw(s).
Slide drawer front assembly as
indicated to unhook mounting tabs.
Pull out to remove.
Installation
Position drawer front on drawer
assembly.
insert mounting tabs into notches on
drawer.
Slide drawer front over to attach.
install retaining screw(s) to hold
drawer front in place.
Mounting
tab
Notch
Retaining
screws
Left side
Slide
Striker
\
Rivet
Drawer
Right side
Siide
Hanger
pointed up
Drawer
front
o
d-
J ,
Bottom
drawer only
Drawers (4)inches
deep or more only
3 4