Craftsman 706.59668 Tool Storage User Manual


 
INFORMATION CENTER INSTALLATION
AND REMOVAL
Tools Required:
Screwdriver, Crosstip
Tape
Removal
Disconnect power from the unit.
Remove enough drawers to reach the
retaining screw under the information
center. (See removing and installing
drawers.)
Loosen (do not remove) the retaining
screw under the information center.
Pull the information center straight out
to remove.
Note: Tape wire to unit before
unplugging the information center. This
will prevent the wire from retracting into
the unit.
Unplug the information center.
Installation
Plug in information center.
Position information center in unit.
Tighten retaining screw enough to
hold information center in place. Do
not overtighten.
Reinstall drawers. (See Removing
and installing drawers.)
Reconnect power to unit.
Set information center as desired.
(See information center operation.)
Tape wire in
place before
disconnectin(
Press to
release
Loosen
retaining screw
FAClA INSTALLATION AND REMOVAL
Tools Required:
3/8" Wrench
drill
5/32" drill bit
Rivet gun
Pliers
To remove facia
Remove enough drawers to reach the
top back inside of the chest.
Remove lock. (See lock installation
and removal.)
Remove chest top. See chest top
installation and removal.
Carefully drill out (2) rivets holding
facia to chest.
Remove facia.
Rivet
To reinstall facia
Position facia on unit. Make sure
connector is on top of chest.
Attach using (2) rivets supplied.
Reinstall lock, chest top, and drawers.
LOCK INSTALLATION AND REMOVAL
LOCK INSTALLATION AND
REMOVAL
To remove lock
Remove enough drawers to reach the
lock retaining clip behind the lock.
Remove lock retaining clip. Pull lock
out to remove.
Actuator
rod
holder
To reinstall lock
Position lock in unit. Install retaining
clip to hold lock in place.
Make sure the back of the actuator
rod is inserted into the actuator rod
holder in the back of the unit.
Push actuator rod toward back of unit
and line up with lock. insert the
actuator rod into the back of the lock.
Test lock operation.
Reinstall drawers.
Connector
Front
Lock
'Lock
retaining
clip
3 4