Filter
Top Products
I CRAFTSMAN°I
LOCK REPLACEMENT
Removal
• Disconnect power from unit.
• For roll-aways, remove work surface.
(See drawer and work surface
installation and removal
• Remove enough drawers to reach the
lock retaining clip behind the lock.
• Remove lock retaining clip. Pull lock
out to remove.
Installation
• Position lock in unit. Install retaining
clip to hold lock in place.
• Make sure the back of the actuator
rod is inserted into the actuator rod
holder in the back of the unit.
• Push actuator rod toward back of unit
and line up with lock. Insert the
actuator rod into the back of the lock.
• Test lock operation.
• Reinstall drawers.
Lock
Actuator
rod
holder
Lock
retaining
clip
Rekeying MASTERLOCK ®ONE-
KEYTM lock
The MASTERLOCK ® ONE_KEyTM
learning lock system allows the
chest and cabinet to be keyed alike.
The lock can also be keyed to most
house keys.
• Insert current key and turn lock to
the right until access notch
appears at top of lock.
• Depress and hold catch through
access notch using re-keying tool
provided.
• Remove key.
• Insert new key.
• Release catch
• Turn lock to center position.
• Remove key
Note: Catch must be depressed to
insert or remove key in right hand
position. Catch may be released
between keys.
Access
keying
DRAWER AND WORK SURFACE
INSTALLATION AND REMOVAL
Note: For pull out work surface without
task light, follow drawer removal
instructions.
DRAWER
• Empty the drawer.
• Fully extend the drawer.
Release
Lever Style - Lift or
lower (depending on the
slide) the release lever
on both sides, (this
allows the slides to ride
over the stops.) Pull out
to remove.
Tab Style - Depress the
release tabs on both
sides, (this allows the
slides to ride over the
stops.) Pull out to
remove.
• To reinstall, carefully align the slides
and push the drawer into the unit until
the drawer stops.
PULL OUT WORK SURFACE WITH
TASK LIGHT
Removal
• Disconnect the power from the unit.
• Remove enough drawers to gain
access to connections in the back of
the roll-away behind the work surface.
• Unplug work surface cord from back of
roll-away.
• Remove and save back retaining clip.
• Disconnect chain inside back of roll-
away. (Move chain toward large round
part of slot. Pull out to remove.)
• Remove the work surface. (See
drawer removal instructions.)
Retaining
Chain
Installation
• To reinstall, carefully align the slides
and push the work surface into the unit
until the work surface stops.
• Depress release tabs in back corners
of the extendable work surface.
• Push the work surface into the unit to
the fully retracted position.
• Extend work surface far enough to
gain access to connections in back.
• Connect chain inside back of roll
away. (Insert chain into the large
round part of the slot. Slide chain to
small end of slot.)
• Insert retaining clip to hold chain in
place.
• Plug work surface cord into back of
roll-away.
• Reconnect power to the unit. (See:
Connecting power.)
• Check work surface and task lighting
for proper operation.
• Reinstall drawers.
Sears, Roebuck and Co., Hoffman Estates, IL 60179, USA
F1623 2