Filter
Top Products
DRAWER AND WORK SURFACE
INSTALLATION AND REMOVAL
Note: For pull out work surface without
task light, follow drawer removal
instructions.
DRAWER
• Empty the drawer.
• Fully extend the drawer.
Release
Lever Style - Lift or
lower (depending on the
slide) the release lever
on both sides, (this
allows the slides to ride
over the stops.) Pull out
to remove.
Tab Style - Depress the
release tabs on both
sides, (this allows the
slides to ride over the
stops.) Pull out to
remove.
• To reinstall, carefully align the slides
and push the drawer into the unit until
the drawer stops.
PULL OUT WORK SURFACE WITH
TASK LIGHT
Removal
• Disconnect the power from the unit.
• Remove enough drawers to gain
access to connections in the back of
the roll-away behind the work
surface.(Follow drawer removal
instructions.)
• Unplug work surface cord from back of
roll-away.
• Remove and save back retaining clip.
• Disconnect chain inside back of roll-
away. (Move chain toward large round
part of slot. Pull out to remove.)
• Remove the work surface. (See
drawer removal instructions.)
Retaining
clip
Chain
Installation
• To reinstall, carefully align the slides
and push the work surface into the unit
until the work surface stops.
• Depress release tabs in back corners
of the extendable work surface.
• Push the work surface into the unit to
the fully retracted position.
• Extend work surface far enough to
gain access to connections in back.
• Connect chain inside back of roll
away. (Insert chain into the large
round part of the slot. Slide chain to
small end of slot.)
• Insert retaining clip to hold chain in
place.
• Plug work surface cord into back of
roll-away.
• Reconnect power to the unit. (See:
Connecting power.)
• Check work surface and task lighting
for proper operation.
• Reinstall drawers.