Filter
Top Products
14 Dell PowerVault 7x0N Systems — Connecting to ATM and FDDI Networks
Example: The abbreviated sample output (showing ELANs on Adapter 2 only) from
this command is as follows:
!"#$#%$$$$$$&'$
()(*
+,*(-+
"#$0$1$22'$$2'$"'%$"1'"'%$'"
32-./
"#$0$1$22'$$2'$"'%$"1'"'%$2
3,*(-+
"#$0$1$22'$$2'$"'%$"1'"'%$''
Interpreting the output: Verify the following for newly configured ATM adapters:
There is an arrow preceding the ELAN name, which indicates that the adapter
has joined the ELAN.
The LAN Type is Ethernet.
The LES ATM Address is a valid ATM address. If the address is all zeros, it indi-
cates a configuration problem at the switch.
$(*!#
You should also check to ensure that the other elements of the ELAN are configured
and operating as expected. For example, you should verify that the LES, LECS, and
BUS ATM addresses are all valid, and that the state of the ELAN is operational.
In addition, you should check the MTU of each ELAN to verify that the setting matches
the configuration created on the switch, by using the elconfig show command.
Syntax: The elconfig show command has the following syntax:
',%-.',
Example: The abbreviated sample output (showing information related to the eigh-
teenKMTU ELAN on adapter 2 only) from this command is as follows:
5002,-?)/
1'
,/
%%!'"#
5%%
8#!"!'"#
65CNPbk0.book Page 14 Monday, September 13, 1999 1:43 PM