Filter
Top Products
20 Dell PowerVault 7x0N Systems — Connecting to ATM and FDDI Networks
!#/* .+$/!
To establish an incoming FORE/IP PVC on the filer, use the following command at the
filer:
2+CCDD
Use the variables as described in Table 2.
!/* .+$ #0
Set up a FORE/IP PVC on the remote ATM host according to the documentation for
that host.
!/* .+$
On the interconnecting ATM switches, assign virtual channels corresponding to the
VPI and VCI entries made on the filer and the remote ATM host according to the doc-
umentation for those switches.
)!#"/* .+$
To display information about all FORE/IP PVCs and other interfaces on a host, type the
following command:
2+
hostname
is the name of a host.
aal
ATM adaptation layer type. It must be 4 or 5, and should be the
AAL type supported by the destination host, which is typically 5.
The default is 5.
encap
Encapsulation type. Specify one of the following encapsulation
types:
null (no encapsulation; this is the default)
llc_routed (IEEE LLC encapsulation for routed power distribu-
tion units [PDUs])
llc_bridged_8023 (IEEE LLC encapsulation for Ethernet/802.3
bridged PDUs)
It should also be the same as the encapsulation type used by the
destination host.
If the encapsulation type is llc_bridged_8023, you must include
addr
.
addr
Six-byte colon-separated destination MAC address.
65CNPbk0.book Page 20 Monday, September 13, 1999 1:43 PM