Filter
Top Products
22 Dell PowerVault 7x0N Systems — Connecting to ATM and FDDI Networks
&'((#
To connect the filer to a single-attachment FDDI network, use a single-attached
FDDI-TP or fiber card to push the cable connector into the card’s connector until it
clicks and locks into place. You can connect to an FDDI single-attachment station or
concentrator. Figure 2 shows a duplex FDDI fiber optic cable connecting to a single-
attached FDDI fiber card.
!"#
$!
You can also use a dual-attached FDDI fiber card with a single-attachment FDDI net-
work. Push the cable connector into the card’s top connector (port B) until it clicks and
locks into place. Leave the card’s bottom connector unused.
%!&'
FDDI-TP
(single-attached)
Category 5 unshielded twisted-pair (UTP) or Category 5
sheath-shielded, 100-ohm twisted-pair (TP) cable with a
TP-MIC plug.
*
RJ45 connector.
*Do not exceed the maximum cable length specifications in the appropriate FDDI ANSI standard.
FDDI fiber
(single-attached or
dual-attached)
Duplex 62.5/125 micron or 50/125 micron multimode
fiber optic cable with
SC connectors.
Duplex SC connector.
duplex FDDI fiber optic cable
65CNPbk0.book Page 22 Monday, September 13, 1999 1:43 PM