Filter
Top Products
32 Dell PowerVault 7x0N Systems — Connecting to ATM and FDDI Networks
-x Detach IP from an incoming SVC or PVC. IP traffic will no longer be accepted
on the specified VPI and VCI.
-f Delete all dynamic address mappings from the ATM ARP table and close all
Switched Virtual Circuits (SVCs) to all hosts in the table.
NOTES
The allowed values for
vpi
,
vci
,
aal
, and
peak
will depend on the capabilities of the
ATM adapter used by the given interface. In addition, certain adapters may only
support discrete peak cell rates. If so, the rate will be set to the closest sup-
ported rate, which is less than the specified rate.
encapsulation
must be one of null (no encapsulation, the default), llc_routed
(IEEE LLC encapsulation for routed PDUs), or llc_bridged_8023 (IEEE LLC encap-
sulation for Ethernet/802.3 bridged PDUs). If
encapsulation
is specified as
llc_bridged_8023, the following argument must be the 6-byte colon separated
destination MAC address.
decapsulation
must be either null (no decapsulation,
the default) or llc (IEEE LLC decapsulation).
CLUSTER CONSIDERATIONS
In takeover mode, the FORE/IP SPANS interface names are those on the live filer,
and in partner mode interface names are those on the failed filer.
In takeover mode, the atmarp command only affects the arp entries of the live
filer, and in partner mode the atmarp command only affects the arp entries of the
failed filer.
SEE ALSO
na_arp(1),
65CNPbk0.book Page 32 Monday, September 13, 1999 1:43 PM