Filter
Top Products
Dell PowerVault 7x0N Systems — Connecting to ATM and FDDI Networks 21
To display information about all the current FORE/IP PVCs, type the following
command:
2+
A display similar to the following appears:
2+
iface=a5 switch.port=f21a2420.56 vpi.vci=0.114 aal=5
encapsulation=NULL
iface=a5 switch.port=f21a2420.25 vpi.vci=0.113 aal=5
encapsulation=NULL
!/* .+$
You can delete outgoing and incoming FORE/IP PVCs.
To delete an outgoing FORE/IP PVC entry, type the following command:
2+
hostname
is the name or IP address of the remote host.
To delete an incoming FORE/IP PVC for a remote host, use the following command:
2+A
iface
is the name of the interface
vpi
and
vci
have the values of the VPI and VCI of the FORE/IP PVC to be deleted for
the specified interface.
You can connect the filer to one of three available FDDI network configurations.
Table 3 describes the three FDDI configurations you can use, and Table 4 lists the
FDDI cabling requirements:
!
Single-attached FDDI Fiber or
FDDI-TP card
*
*Do not exceed the maximum cable length specifications in the appropriate FDDI American National
Standards Institute (ANSI) standard.
Dual-attached
FDDI fiber card
Dual-attached
FDDI fiber card
65CNPbk0.book Page 21 Monday, September 13, 1999 1:43 PM