Filter
Top Products
12
ADJUSTING TABLE SQUARE
WITH SANDING DISC
1. DISCONNECT MACHINE FROM POWER SOURCE.
2. Using a combination square (C) Fig. 28, place one
end of the square on the table with the other end against
the sanding disc as shown in Fig. 28, and check to see
if the table is 90 degrees to the disc.
3. If the table surface is not 90 degrees to the disc,
loosen table lock knob (A) Fig. 28, adjust table square
with disc and tighten lock knob (A).
4. Adjust pointer (B) Fig. 28, to the “0” degree mark on
the angle scale.
ADJUSTING MITER GAGE
SLOT PARALLEL WITH
SANDING DISC
1. DISCONNECT MACHINE FROM POWER SOURCE.
2. Using a combination square (A) in the miter gage
slot, check the distance from the slot to each end of the
sanding disc, as shown in Figs. 29 and 30. This distance
should be the same.
3. If an adjustment to the table is necessary, loosen the
three screws (B) Fig. 31, that fasten the table to the table
mounting bracket and trunnion and adjust the table ac-
cordingly - then tighten three screws (B). Wrench not
supplied.
Fig. 28
Fig. 29
Fig. 31
Fig. 30
A
B
C
A
A
B