Filter
Top Products
16
REPLACING SANDING DISC
When it becomes necessary to replace the sanding disc, proceed as follows:
Fig. 44
1. DISCONNECT MACHINE FROM POWER SOURCE.
2. Loosen screw (A) Fig. 44, and remove table assem-
bly (B).
3. Remove three screws (C) Fig. 45, and lower cover
(D).
4. Peel off old disc (E) as shown in Fig. 46.
5. Make sure the disc plate (F) Fig. 46, is clean and peel
backing from new sanding disc. Press the new sanding
disc firmly into position on disc plate (F) and replace
lower cover and table assembly which were removed in
STEPS 2 and 3.
Fig. 45
Fig. 46
OPERATION
Fig. 48Fig. 47
SURFACING OR EDGE SANDING WITH SANDING BELT
When surfacing (see Fig. 47), or edge sanding (see Fig. 48), the sanding arm is in the horizontal position
and the backstop (A) Fig. 47 and Fig. 48, must always be used to prevent the workpiece from being
carried along the belt. Always hold the workpiece firmly, keeping your fingers away from the sanding
belt. Always keep the end of the workpiece against the backstop and move the workpiece evenly
across the sanding belt. Apply only enough pressure to allow the sanding belt to remove material. Use
extra caution when sanding very thin pieces.
WARNING: THE EDGE OF THE BACKSTOP MUST BE POSITIONED A MAXIMUM OF 1/16
INCH AWAY FROM THE SANDING BELT TO AVOID TRAPPING THE WORK OR FINGERS
BETWEEN THE BACKSTOP AND SANDING BELT.
A
B
D
C
E
F
A
A