Filter
Top Products
10
Fig. 18
Fig. 19
Fig. 20
Fig. 21
DUST CHUTE
The machine features a handy built-in dust chute (P)
Fig. 18, which allows wood chips to fall out of the way
and keeps the depth stop clear for accurate repetitive
boring operations.
SETTING DRILLING DEPTH
1. Make certain the machine is disconnected from
the power source, and air supply.
2. Loosen locknut (A) Fig. 18.
3. Manually push the boring head carriage (B) Fig. 19,
forward as far as it will go.
4. Rotate threaded rod (C) Fig. 20, as necessary to
obtain desired drill depth setting. NOTE: Drilling depth
setting is obtained by measuring from rear fence (D) Fig.
20, of table to tip of drill bit (F) as shown. Manually push
the boring head carriage (B) forward or backward until
the desired depth setting is obtained.
5. Rotate threaded rod (C) Fig. 20, until the depth stop
(G) is firmly against the back wall (H).
6. Tighten locknut (A) Fig. 20, after setting drilling
depth.
7. Assemble safety shield (J) Fig. 21, over boring head
(K) with four screws, two of which are shown at (L).
F
D
G
H
B
A
C
A
P
B
K
J
L