Filter
Top Products
6
Fig. 6
Fig. 8
Fig. 9
Fig. 10
Fig. 7
ASSEMBLING
TABLE TO MACHINE
1. Thread two lock knobs (A) Fig. 6, into holes (B) at the
underside of table (C).
2. Place table (C) Fig. 7, onto ledge (D) Fig. 8, of
machine. Align two holes in machine ledge (D) Fig. 8,
with two threaded holes in the underside of table (C) and
fasten as shown, with 2 one inch-long screws,
lockwashers and flat washers (E) Fig. 8.
ASSEMBLING
MITER GAGE
1. Remove knob and flat washer (A) Fig. 9, from
threaded rod of miter gage bar (B).
2. Place miter gage body (C) Fig. 10, over threaded rod
of miter gage bar (B) and reassemble flat washer and
knob, which were removed from miter gage bar (B) in
STEP 1. NOTE: Make certain pin (D) Fig. 9, located on
underside
of miter gage body (B) engages hole (E) in miter gage bar
(B) when assembling miter gage.
C
B
A
A
D
C
C
D
E
B
E
A
D
B
C
A