Filter
Top Products
11
STARTING AND STOPPING
DRILL ROTATION
1. To start drill rotation, push green start button (A)
Fig. 24.
2. To stop drill rotation, push red stop button (B) Fig.
24.
3. IMPORTANT: The air supply must be on and the foot
pedal depressed to lower work holddown and activate
carriage movement.
Fig. 24
Fig. 23
Fig. 22
ALIGNING TABLE
90 DEGREES TO
THE DRILL BITS
1. Make certain the machine is disconnected from
the power source and air supply.
2. With the drill bits in position, manually push the car-
riage forward as far as it will go.
3. Place a square (A) Fig. 22, against rear fence (B) and
drill bits (C) as shown and check to see if the table is
aligned 90 degrees to the drill bits.
4. If an adjustment is necessary, loosen two screws (D)
Fig. 23, and align table (E) Fig. 22, so it is 90 degrees to
drill bits (C). Tighten two screws (D) Fig. 23, after
adjustment is made.
5. Recheck the drilling depth setting.
E
B
C
A
D
A
B