Filter
Top Products
13
The forward speed/feed rate of carriage assembly (A)
Fig. 32, is governed by the air pressure. To adjust the
speed/feed rate of carriage assembly (A) Fig. 32,
proceed as follows:
1. Make certain the machine is disconnected from
the power source.
2. Loosen locknut (B) Fig. 32, and rotate air pressure
valve (C) as necessary. NOTE: Rotating pressure valve
(C) clockwise will decrease air pressure and slow up
carriage (A) movement. Rotating air pressure valve (C)
Fig. 32, counterclockwise will increase air pressure and
speed up carriage (A) movement.
3. Tighten locknut (B) Fig. 32, after speed/feed rate of
carriage assembly (A) is made.
Fig. 31
Fig. 30
Fig. 32
ADJUSTING MITER GAGE
The miter gage (A) Fig. 30, can be installed at three po-
sitions on the table, left, right or center, depending on the
drilling operation.
1. To adjust the position and angle of the miter gage (A)
Fig. 30, loosen lock knob (B).
2. Tighten lock knob after adjustment is made.
ADJUSTING
TABLE HEIGHT
The table (A) Fig. 31, moves on dovetailed ways (B) at the
front of the machine.
1. To raise or lower table (A) Fig. 31, rotate knob (C).
ADJUSTING SPEED/FEED RATE OF CARRIAGE ASSEMBLY
B
A
A
C
B
A
B
C