Filter
Top Products
19
1. Remove the blade guard and place the cuttinghead in a cross-cut position (Fig. 40).
2. Place a square (A) Fig. 40 against saw blade (B) and table, and see if the blade (B) is square with the table. Make
certain the square is between the teeth of the saw blade.
3. To adjust, loosen the two bolts (C) Fig. 41.
4. Loosen the screw (D) Fig. 42, located inside of the yoke (E).
5. Hold the cuttinghead with your left hand (Fig. 43). Loosen the bevel clamp handle (F) and tilt the motor until the
saw blade is flush against the square.
6. After adjusting, turn the bevel clamp handle (F) Fig. 44 counter-clockwise to lock the motor in position.
NOTE: If the bevel clamp handle (F) does not completely lock the motor, pull out the handle and reposition it on the
serrated nut.
7. Tighten the clamp bolt (D) Fig. 42 and two bolts (C) Fig. 41.
8. Loosen the screw (G) Fig. 45. Move pointer (H) to zero mark on the bevel scale (J). Tighten screw (G).
9. Replace the blade guard that was removed in STEP 2.
Fig. 40
Fig. 41
Fig. 42
Fig. 43
A
B
C
Fig. 44
Fig. 45
E
D
F
J
H
G
F