Filter
Top Products
10
1. The Magnetic Starter on/off switch (A) Fig. 9 comes
attached to a mounting bracket on the right side of
the machine. Remove it.
2. Insert a 5/16-18x1" flat head screw (D) with a 5/16"
flat washer (E) through the hole (G) in the front lip of
the extension table and through the switch bracket
(A). Use a 5/16-18 hex nut to loosely attach the
switch and switch bracket (A) Fig. 10 to the inside
front lip of extension table. with (F) through hole (G).
3. Attach the side of switch bracket (A) Fig. 11 to the
inside of the extension table using the 7/16-20x1-
1/4" screw (C) and 7/16" flat washer.
4. Tighten all hardware securely.
ATTACHING THE MAGNETIC STARTER ON/OFF SWITCH
Fig. 9
Fig. 10
Fig. 11
A
D
F
E
G
A
D
C
A
ATTACHING THE BLADE GUARD AND SPLITTER ASSEMBLY
DISCONNECT THE MACHINE FROM THE POWER SOURCE!
1. Remove the table insert Fig. 12. Raise the saw arbor by turning the height adjusting handle on the front of the saw
counter-clockwise as far as it will go. Then turn the angle-adjusting handle on the front of the saw clockwise as far
as it will go. Remove the saw blade from the machine by following the instructions in section “CHANGING THE SAW
BLADE”.
2. The inside splitter mounting bracket (A) Fig. 13 comes attached to the inside of the saw and was aligned with the
inside blade flange (B) at the factory.
Fig. 12
Fig. 13
C
A
B
422-04-651-0064 - 06-20-05.qxd 6/20/05 1:42 PM Page 10