Delta 34-801 Saw User Manual


 
14
Use four #10 x 1/2" sheet metal screws to attach the rip
fence holder brackets (A) and (B) Fig. 33 to the four holes
located in the left hand side of the saw cabinet.
The Unisaw is supplied with a dust chute adapter to
connect a 4" diameter dust collector hose to the
machine. Align the four holes in the adapter (A) Fig. 34
with the four holes in the back of the saw cabinet (B).
Attach the dust chute adapter with four #10 x 1/2" sheet
metal screws.
NOTE: Do not mount the dust chute adapter unless you
use a dust collection system with the saw. Without the
system, a dust chute adapter will restrict the gravity feed
opening for saw dust removal.
You can store the miter gauge and arbor wrenches in the
slots (A) Fig. 32 provided in the motor cover.
2. Place the motor cover (A) in the opening of the
Unisaw (Fig. 31). Place the rear motor cover clips
inside the motor opening and push the front of the
motor cover until all 4 motor cover clips are engaged
with the motor cover opening in the Unisaw.
NOTE: To remove the motor cover, depress both sides
of the cover and pull outward.
MITER GAUGE HOLDER AND WRENCH HOLDER
Fig. 31
Fig. 32
ATTACHING THE RIP FENCE HOLDER BRACKETS
Fig. 33
A
A
A
B
ATTACHING THE DUST CHUTE ADAPTER
A
B
Fig. 34
422-04-651-0064 - 06-20-05.qxd 6/20/05 1:43 PM Page 14