Filter
Top Products
13
12. Use a straight edge (A) Fig. 25 to make certain that
the splitter (P) is aligned with the saw blade (B). Use
a square (C) Figs. 27 and 28 to make certain that the
saw blade (B) Fig. 26 and splitter (P) Fig. 27 are 90°
to the table surface. Tighten all splitter mounting
hardware (D) Fig. 27 and re-check the alignment.
13. Hold the clear blade guard (X) Fig. and lower the saw
blade. Attach the table insert (E) Fig. 30 into the
opening on the saw table.
Fig. 26
Fig. 27
Fig. 28
B
C
E
D
C
P
1. Raise the saw arbor by turning the height adjusting
handle on the front of the saw counter-clockwise as
far as it will go. Then turn the angle adjusting handle
on the front of the saw clockwise as far as it will go.
2. Fasten motor cord (A) Fig. 29 to the saw frame cross
member (B), using the cable tie (C) supplied with the
saw.
CAUTION: Before tightening the cable tie, make certain
that the electrical cord (A) is free of any interference from
the motor or saw blade in all positions.
3. After the cable tie is tightened, cut off the excess tail
(C) Fig. 29.
FASTENING THE MOTOR CORD TO THE SAW FRAME
A
B
C
Fig. 29
ATTACHING MOTOR COVER
NOTE: If you have an “LVC” (Starter Box) version
Unisaw, you will have to attach two bottom spring
clips to the motor cover. The spring clips come
attached to the “GPE version Unisaw.
1. Attach the two motor cover clips to the motor cover.
Align the hole in the motor cover clip with the hole
in the motor cover. Place a 13/64 flat washer on a
10-32 x 1/2" screw (A) Fig. 30. Insert the screw
through the hole in the motor cover clip and thread
the screw (A) into the tapped hole in the motor cover.
Fig. 30
A
422-04-651-0064 - 06-20-05.qxd 6/20/05 1:43 PM Page 13