Filter
Top Products
20
When ripping material with a veneer facing that extends
over the material, the fence (A) should be in the horizontal
position with the veneer (B) extending over the lip of the
fence, as shown in Fig. 53
When ripping material with a veneer facing and the
material is not thick enough for the veneer to extend over
the lip of the fence or if the veneer facing (B) is on both
sides of the material, as shown in Fig. 54, the fence can be
positioned slightly above the surface of the table. The
veneer can be placed between the fence and the table or
the veneer can straddle the fence with the material solidly
against the fence.
In some cases it may be desirable to use the fence on the left side of the saw blade. This is easily accomplished by
repositioning the fence (A) Figs. 55 and 56, fence clamp bar (B), and lock knobs (C) so that the fence (A) will be attached to
the right side of the fence body, as shown in Fig. 56. The complete fence assembly (D) Fig. 56, can easily be moved to the
left side of the saw table.
RIPPING ON LEFT SIDE OF SAW BLADE
Fig. 53
Fig. 54
Fig. 55
Fig. 56
B
A
B
C
B
A
C
A
D
422-04-651-0064 - 06-20-05.qxd 6/20/05 1:44 PM Page 20