Filter
Top Products
Insert the miter gauge bar into the miter gauge slot on the table. Attach the washer and lock handle (A) Fig. 43 to the
miter gauge bar.
The miter gauge is equipped with adjustable index stops at 90° and 45° right and left. You can make adjustments to the
index stops by tightening or loosening the three adjusting screws (B) Fig. 48 with the supplied Hex wrench
To rotate the miter gauge, loosen the lock knob (A) Fig. 44 and move the body of the miter gauge (C).
The miter gauge body will stop at 90° and 45° both right
and left. To rotate the miter gauge body past these points,
move the stop link (D) Fig. 44 up and out of the way.
The head of the miter gauge pivots on a special tapered
screw (G) Fig. 45. If the miter gauge head does not pivot
freely, or pivots too freely, adjust it by loosening the set
screw (H) Fig. 45, and turning the screw (G) in or out.
NOTE: Tighten screw (H) after you make the adjustment.
Your miter gauge is equipped with a plate (E) Fig. 45 that
fits into the T-Slot groove in the table. This allows the
miter gauge head to go off the front edge of the table
without falling, allowing for a longer cut off capacity.
17
Place a straight edge (B) across the table at both ends of
the table insert (Fig. 42). The table insert (A) should
always be level with the table. To adjust, turn the
adjusting screws (C), with a supplied hex wrench.
NOTE: You can store the hex wrenches in the miter
gauge handle when not in use. Remove the top cap
(A) Fig. 44 for storage.
ADJUSTING THE TABLE INSERT
MITER GAUGE OPERATION AND ADJUSTMENT
Fig. 42
Fig. 43
Fig. 44
Fig. 45
A
C
B
B
D
A
C
C
A
B
422-04-651-0064 - 06-20-05.qxd 6/20/05 1:43 PM Page 17